Hoppy Easter Card

Hope Your Easter Basket Is Filled With Love!

Hope Your Easter Basket Is Filled With Love!

Bunny Butt Design from PPBN – http://www.ppbndesigns.com/products/wheres-my-basket-scrapbook-page-kit.html
As Cute As… Font – http://www.dafont.com/search.php?q=as+cute+as

The Bunny feet on the sentiment are from the pattern from the Bunny Butt – I converted them to a png using Adobe Illustrator then inserted them into InDesign where I created my card insert.

20160224_155137   Supplies:
1.  3 Stampin Up punches – 2 1/2″ Circle, 1 3/4″ x 7/8″ Oval, Scallop Oval (about same size)
2.  Gray, Pink, White, Brown and Black Cardstock
3.  Tree Bark Embossing folder
4.  Foam and adhesive
5.  Brown Ink Pad
6.  Score board, craft knife
7.  Computer / Printer
8.  Font and File (listed above)

Cute 2 pieces of brown cardstock – 5.25″x 4″   Run one of the pieces through with the Tree Bark Embossing Folder (Leave the other one smooth)

20160224_155455  20160224_15555120160224_155624

Ink the Cardstock with a darker brown ink pad to make the lines stand out – also ink the edges.

20160224_15565920160224_155759

Bunny Card – This is a pdf that will allow you to print the sentiment and the Hoppy Easter for the front of the card.

Once they are printed out, punch the Hoppy Easter with the small oval punch, then punch a dark pink scalloped oval for behind it.
Cut out the inside sentiment to measure 3 3/4″ x 5″ – Once I cute the 8 1/2 x 11 in half then half again I had to cute 1/2″ from the top of the sentiment and then 1/4″ from the other two sides – in the picture below I measured over 4″ then cut the 1/4″ from the outside (leaving the remaining piece larger than half.
20160224_16352320160224_163839

Using the 2 1/2″ Circle punch – Punch out a circle from the brown tree piece.  Then take a 3″ x 3″ piece of black cardstock and glue it behind the circle so that it looks like the tree is hollow.

20160224_16391220160224_163955

20160224_16403420160224_164055

Cut a piece of White Cardstock (as your base) at 5 1/2″ x 4 1/4″ – Score at 4 1/4″ on the 5 1/2″ side.

20160224_164218

Glue the backgrounds and sentiment to the base of the card.

20160224_16434620160224_16442320160224_164452

Using your cutting machine, cut out the Bunny Butt (link above).  You can see actual piece sizes in photo.  Bunny Butt should be about 2″ wide (not including the legs).

20160224_16472420160224_164737

20160224_16474920160224_164812

Cut the Bunny pieces and put some foam behind it.

20160224_16581020160224_16594420160224_170030

Place Bunny so he looks like he is climbing into the whole – then place the sentiment underneath.

20160224_17005920160224_170121